3D Printed Interdigitated Electrodes for Cardiac Biomarker Detection

The identification of biomarkers has significant benefits for early disease diagnosis and treatment. Hence, there is an increasing demand for low-cost, disposable point-of-care diagnostic devices for rapid and specific biomarker detection, with good sensitivity and range. Interdigitated electrodes (IDEs) are among the most widely used transducers, especially in chemical and biological sensors, because of their high sensitivity, low cost, and straightforward manufacturing procedure. In this work, a simple 3D printed IDE structure has been developed for cardiac troponin I detection to indicate the risk of acute myocardial infarction (AMI). IDEs have been fabricated using 3D printing technique and the electrically conductive composite polylactic acid (PLA) filament being utilized for the fabrication of electrodes. The demonstrated cardiac troponin I sensor has a calculated quantification limit and detection limit of 0.233 ng ml $^{\mathbf {-{1}}}$ and 76.97 pg ml $^{\mathbf {-{1}}}$ , respectively which are clinically significant ranges for AMI identification. Electrochemical analytical techniques, such as electrochemical impedance spectroscopy (EIS) and cyclic voltammetry (CV), were carried out for the detection of analyte concentration. Furthermore, using this fabrication methodology IDEs can be fabricated for under US 0.4 which can be utilized to detect several other biomarkers.