Robust Active and Reactive Power Control by using Single-Phase Grid connected H-Bridge Inverter

In a single-phase power network, inverters can be used to control the active and reactive power between sources. This task can be achieved by proper control of the current of the single-phase inverter. The current controllers using dq-frame components have a wide application area because of their superior features such as zero steady-state error and using the DC quantities. In this study, the active and reactive power between sources in a single-phase power system consisting of an AC voltage source and a DC voltage source are controlled via dq-frame based super twisting sliding mode (ST-SMC) current controller. For this aim, a Matlab/Simulink model is constructed. The model includes single phase H-bridge inverter, DC voltage source, AC voltage source, AC load, LCL filter and control unit. Two super twisting sliding mode controllers are used to control d and q-axis currents. Decoupling terms are added to output of each controller for independent control of active and reactive power. The simulation studies are performed to demonstrate the controller's ability to provide/absorb active and reactive power. To demonstrate the ability to provide/absorb active power, the d-axis current command is set to 10 A up to 2 s from the start of the simulation, and then, it is set to – 10 A between 2 s to 4 s. To demonstrate the ability to provide/absorb reactive power, the q-axis current command is set to 10 A up to 2 s from the start of the simulation, and then, it is set to – 10 A between 2 s to 4 s. The simulation results show that the controller provides/absorbs the desired active and reactive power quickly and without steady-state error.