Online Correction of Distorted OTDR Traces Caused by Stimulated Raman Scattering in Wideband Optical Networks

The recent interest in the development of wideband optical networks brings up challenges for in-service optical time-domain reflectometer (OTDR) operation due to the stimulated Raman scattering (SRS) effect. Depending on its wavelength, OTDR probe pulses can be pumped or depleted by wideband traffic signal during the propagation along a fiber span. Consequently, the measured traces are distorted and unable to provide accurate fiber loss profiles. In order to correct distorted traces in a real-time online manner, we propose a dither-based method that doesn't require any prior information on channel loading condition or fiber parameters. The proposed method prompts a low frequency sinusoidal power dither on the traffic light, and a large number of OTDR traces are collected in the positive and negative half cycles, respectively. Averaging traces from the two half cycles generates two differential traces, and SRS gain can be calculated and used for correction. The induced dither causes power variation of traffic signal, but this impact can be minimized substantially by employing a second dither at the end of fiber span properly. The proposed method is verified experimentally in a
$ 700$
km multiple spans fiber link. In the presence of SRS effect, the mean of absolute errors between the distorted traces and the actual loss trace are about
$ 0.72$
dB and
$ 0.3$
dB when OTDR pulses and traffic co-propagate and counter-propagate, respectively. By applying the proposed method, these errors are reduced to around
$ 0.07$
dB and
$ 0.05$
dB correspondingly. Meanwhile, performance of data transmission in terms of bit error rate is monitored during the process, and no penalty is observed.