Spatially Highly Constrained Auxiliary Rotary Actuator for a Novel Total Artificial Heart

In the context of a collaboration between the
Medical University of Vienna
, the
Power Electronic Systems Laboratory
of
ETH Zurich
, and
Charité Berlin
, the novel implantable total artificial heart
ShuttlePump
is currently being developed. Its novel low-complexity pumping concept requires a compact linear–rotary actuator (LiRA). The linear actuator (LA) part was designed, realized, and experimentally verified in previous work, and it can provide a peak axial force of about 45 N with about 8 W of continuous power dissipation. This article presents the details of the rotary actuator (RA) part. This has considerably lower output power requirements (about 100 mW) due to the low operating torque and angular speed (3.1 mN
$\cdot$
m and up to 300 r/min, respectively). However, the RA is highly constrained spatially, as it needs to be integrated very close to the previously realized LA. This forces a permanent magnet synchronous machine (PMSM) design with a rotor only partially equipped with permanent magnets and stators covering only half of the total circumference, which introduces a considerable cogging component to the total torque. The proposed PMSM is, hence, optimized using finite-element method simulations to select a final design with low power losses and low cogging-induced angular speed ripple. The machine is realized as a hardware prototype, and the experimental measurements confirm that the proposed RA can meet the continuous torque requirement with 324 mW of power losses. The successful implementation of the RA (and LA) finally verifies the practical feasibility of the integrated LiRA and provides the basis for a comprehensive test of the complete
ShuttlePump
in a hydraulic test rig in the course of further research.