Simultaneous and Proportional Control of Wrist and Hand Movements Based on a Neural-Driven Musculoskeletal Model

Human-machine interfaces (HMIs) based on electromyography (EMG) signals have been developed for simultaneous and proportional control (SPC) of multiple degrees of freedom (DoFs). The EMG-driven musculoskeletal model (MM) has been used in HMIs to predict human movements in prosthetic and robotic control. However, the neural information extracted from surface EMG signals may be distorted due to their limitations. With the development of high density (HD) EMG decomposition, accurate neural drive signals can be extracted from surface EMG signals. In this study, a neural-driven MM was proposed to predict metacarpophalangeal (MCP) joint flexion/extension and wrist joint flexion/extension. Ten non-disabled subjects (male) were recruited and tested. Four 64-channel electrode grids were attached to four forearm muscles of each subject to record the HD EMG signals. The joint angles were recorded synchronously. The acquired HD EMG signals were decomposed to extract the motor unit (MU) discharge for estimating the neural drive, which was then used as the input to the MM to calculate the muscle activation and predict the joint movements. The Pearson’s correlation coefficient (r) and the normalized root mean square error (NRMSE) between the predicted joint angles and the measured joint angles were calculated to quantify the estimation performance. Compared to the EMG-driven MM, the neural-driven MM attained higher r values and lower NRMSE values. Although the results were limited to an offline application and to a limited number of DoFs, they indicated that the neural-driven MM outperforms the EMG-driven MM in prediction accuracy and robustness. The proposed neural-driven MM for HMI can obtain more accurate neural commands and may have great potential for medical rehabilitation and robot control.