Flexi-EIT: A Flexible and Reconfigurable Active Electrode Electrical Impedance Tomography System

Electrical Impedance Tomography (EIT) systems have shown great promise in many fields such as real-time wearable healthcare imaging, but their fixed number of electrodes and placement locations limit the system's flexibility and adaptability for further advancement. In this article, we propose a flexible and reconfigurable EIT system (Flexi-EIT) based on digital active electrode (DAE) architecture to address these limitations. By integrating a reconfigurable number of up to 32 replaceable DAEs into the flexible printed circuit (FPC) based wearable electrode belt, we can enable rapid, reliable, and easy placement while maintaining high device flexibility and reliability. We also explore hardware-software co-optimization image reconstruction solutions to balance the size and accuracy of the model, the power consumption, and the real-time latency. Each DAE is designed using commercial chips and fabricated on a printed circuit board (PCB) measuring 13.1 mm × 24.4 mm and weighing 2 grams. In current excitation mode, it can provide programmable sinusoidal current signal output with frequencies up to 100 kHz and amplitudes up to 1 mA
$_{p-p}$
that meets IEC 60601-1 standard. In voltage acquisition mode, it can pre-amplify, filter, and digitize the external response voltage signal, improving the robustness of the system while avoiding the need for subsequent analog signal processing circuits. Measured results on a mesh phantom demonstrate that the Flexi-EIT system can be easily configured with different numbers of DAEs and scan patterns to provide EIT measurement frames at 38 fps and real-time EIT images with at least 5 fps, showing the potential to be deployed in a variety of application scenarios and providing the optimal balance of system performance and hardware resource usage solutions.