Optimum Design of Metal Stamping Parameters for Automobile Side Cover

The purpose of this study is to optimize the process parameters for sheet metal pressing of automotive side panels. This research is mainly based on the mold design parameters, which are: (1) thickness of molding material, (2) rounded corner of punch; (3) gap between upper and lower dies, etc. optimization parameters. The deformation of the simulated value of the final stamping verification experiment is: measuring point A2.5486X0.2916mm, the actual measured deformation is 2mmX(−0.27714mm), and the error value is 11%. Measurement point B: The simulated deformation is 5.0986mmX (−0.27714mm), the actual measured deformation is 4.85mmX (−1.5mm), and the error value is 14%. These are all within the acceptable range of sheet metal forming, and relevant information can be provided Partner reference.