Handling Qualities Assessment of Manual Lunar Landing with Display Augmentation

Research and development is being conducted to support data-driven design decisions for manual control and human involvement in the lunar landing task under the Human Landing System (HLS) program within the Artemis campaign. A human-in-the-loop simulator evaluation of the manual control of a lunar landing vehicle in the final approach and landing phase was conducted at NASA Langley Research Center in the Lunar Flight Deck simulator using the Altair Design and Analysis Cycle (DAC)-2 government reference vehicle. The objective was to perform a direct comparison of control law types with display aiding for various rotational control powers being considered under HLS. Ten subjects (four NASA test pilots and six current pilot astronauts) provided Cooper-Harper ratings, NASA Task Load Index workload ratings, and qualitative comments. The piloting task was to assume manual control of the vehicle (including vertical descent rate) at 150 m above the landing zone, fly to a redesignated landing target (which was up to 75 m radially from the center of the landing zone) and to touch down within a position accuracy of 5m. The data showed that the display augmentation in the form of a “hover cue” significantly improved the pilot's ability to control translation and create satisfactory handling qualities for otherwise sluggish configurations; however, the investigation also showed that display augmentation is not a panacea. Handling qualities problems, including pilot-induced oscillations, and higher workload for the lowest control powers can still be evident.