Packaging Induced Stresses in Embedded and Molded GaN Power Electronics Components

Residual stresses created during the packaging process can adversely affect the reliability of electronics components. We used incremental hole-drilling method, following the ASTM E 837-20 standard, to measure packaging induced residual stresses in discrete packages of power electronics components. For this purpose, we bonded a strain gauge on the surface of a Gallium Nitride (GaN) power component, drilled a hole through the thickness of the component in several incremental steps, recorded the relaxed strain data on the sample surface using the strain gauge, and finally calculated the residual stresses from the measured strain data. The recorded strains and the residual stresses are related by the compliance coefficients. For the hole drilling method in the isotropic materials, the compliance coefficients are calculated from the analytical solutions, and available in the ASTM standard. But for the orthotropic multilayered components typically found in microelectronics assemblies, numerical solutions are necessary. We developed a subroutine in ANSYS APDL to calculate the compliance coefficients of the hole drilling test in the molded and embedded power electronics components. This can extend the capability of the hole drilling method to determine residual stresses in more complex layered structures found in electronics.