Highly Efficient Calibration of Antenna Arrays by Active Targets in the Near-Field

To enhance the capabilities of high-resolution imaging or beamforming, the trend goes towards arrays with high-channel count and large aperture sizes. The operation at increasing mm-wave frequencies exacerbates the consequences of manufacturing tolerances on the array performance, further necessitating the development of high-quality calibrations. Thereby, a large number of array response vectors, addressed in the following as data points, is stored. Typically, one data point is measured at a time for each angle. To reduce the calibration effort, hereby defined as the number of required measurements, a calibration setup employing active calibration targets (ACT) is proposed. This setup allows the storage of a multitude of data points within a single measurement. In addition, this measurement setup is placed in the near-field of the array to relax the requirements on the size of the anechoic chamber. Employing multiple targets makes it challenging to compensate the near-field effects. Therefore, methods are discussed to ensure a consistent quality of the calibration considering the near-field influences from the ACTs. Exemplary measurements deploying an antenna array operating at 78.5 GHz demonstrate that this calibration measurement setup employing three ACTs placed in the near-field of the array reduces the calibration effort by a factor of 3 compared to state-of-the-art setups. The average deviation of the antenna phase relations amounts to 4.1 degree, proving that the presented setup achieves the same calibration quality as state-of-the-art setups.