Traveling wave structure optimization for the NLC

The JLC/NLC linac must accelerate multi-bunch beams in order to obtain a luminosity >3/spl times/10/sup 34/ cm/sup -2/ sec/sup -1/ at a center of mass energy of 1 TeV. It is essential for the structure design to minimize the long and short-range dipole wakefields to prevent emittance degradation and the beam breakup instability (BBU). In addition, the structures must operate at a high RF gradient to minimize the linac cost. High-power testing of prototype structures at SLAC has shown noticeable damage. The damage is largest in the front of the structure, where the group velocity is high, and there is minimal or no damage at the back end, where the group velocity is low. Theoretical analysis using a simple circuit model suggests using structures with a lower group velocity, on the order of a few percent, would be a way of avoiding damage. For the standard 2/spl pi//3 accelerating mode, it is difficult to lower the group velocity without losing efficiency or increasing the wakefields. With this in mind, we have taken the phase advance as an additional parameter in structure optimization. We found that a low group velocity structure at higher phase advance can maintain high RF efficiency and low wakefields. In this paper, we study the impact of phase advance on structure performance. We then optimize the NLC S-band and X-band structures to meet design requirements.