Low-Power Low-Complexity FM-UWB Hybrid Transceiver for Communication and Ranging

A frequency-modulated ultrawideband (FM-UWB) hybrid transceiver, with a high system reuse ratio up to 90%, is fabricated in the 65-nm CMOS process for both short-range wireless communication and high-resolution radar ranging. The radio frequency (RF) front-ends (RFFEs) based on module stacking and current reuse achieve significant RF power savings of about 30% and 50% for the transmitter and the receiver (RX), respectively. The presented IF zero-crossing delay discrimination benefits a high radar resolution less than 1 cm. A multimode relaxation oscillator (OSC) for the reconfigured triangular subcarrier generation and a dual-path ring voltage-controlled oscillator (VCO) for the linear FM, stacked by a wideband push–pull power amplifier (PA), generate an FCC-compliant UWB signal. An active balun embedded low-noise amplifier (LNA) and two symmetric-detuning band-passed filters (BPFs) are stacked with the bandwidth extension to linearly demodulate the UWB FM signal. Experimental results show that the 3.75–4.25-GHz hybrid transceiver has an energy efficiency of 1.9 nJ/bit with an active area of 0.7 mm2 and a power dissipation of 1.9 mW and achieves the RX sensitivity of −71 dBm and the transmitted power of −14.1 dBm, with a bit error rate (BER) of 10−4 at a distance of 4 m under the data rate (DR) of 0.1–1.0 Mbps. The transceiver also achieves the noise figure (NF) of 4.8 dB and the phase noise of −78.6 dBc/Hz at 1-MHz offset frequency.