Monitoring and Condition Assessment of Insulation Paper of Distribution Transformers With Novel Oil Spectroscopy Method

Measuring the furan concentration in transformer oil is one of the most common methods of monitoring and evaluating insulation paper and estimating its degree of polymerization (DP). Here, methods for measuring furan concentration, especially ultraviolet-visible (UV-Vis) spectroscopy method, are reviewed on the old transformers oil. The results show that the excessive turbidity of old oils and noise at low wavelengths are the main disadvantages of this method, which reduce the measurements accuracy. The following solutions are proposed to overcome these disadvantages: 1) diluting insulation oil with hexane to reduce absorption intensity and 2) using average absorption at a given wavelength to reduce noise impact. These solutions are applied to the oil samples of ten old distribution transformer. It is observed that the correlation between 2-furaldehyde (2-FAL) concentration and average absorption intensity in 190–600 nm wavelength range is equal to ${R}^{{2}} =0.98$ . A mathematical equation for calculating 2-FAL concentration based on average absorption is presented. It has been shown that to reduce the test time, a 190–400 nm range is the optimal measurement wavelength range. The results show that the average difference between the values of DP in the proposed method and the direct measurement method is equal to 77.5.