Partial Discharge Detection in Gas-Insulated Switchgears Using Sensors Integrated With UHF and Optical Sensing Methods

Partial discharge (PD) detection from protrusion defects is performed in an actual gas-insulated switchgears (GISs) based on a built-in sensor integrated with fluorescent fiber and ultrahigh frequency (UHF) antenna. The characteristics of both optical and UHF signals are analyzed in terms of inception voltage, pulse distribution, and statistical characteristics including the phase-resolved partial discharge (PRPD) pattern and PD number. In the experiment, protrusions with different curvatures are adopted to investigate the reason for the differences in the characteristics of UHF and optical signals. The results show that UHF and optical methods have different detection sensitivity for different discharge types owing to the different energies of electromagnetic waves and optical signals radiated in different discharge types. The optical method can easily detect avalanche discharge, while the UHF method can easily detect streamer discharge. This difference leads to the difference of the PD characteristics obtained by the two partial methods. For example, for the PD of small curvature protrusions, the PD inception voltage (PDIV) of the optical method is lower than that of the UHF method, because the defect triggers avalanche discharge. Moreover, the optical and UHF signal pulses are not always simultaneous in the time domain because they detect different discharge types. The PRPD patterns obtained by the optical method have a wider phase distribution than the UHF method because the optical method can detect avalanche discharge under low voltage.