Fabrication of Polymer Membrane-Suspended Microstructures on Printed Circuit Boards

When microelectromechanical systems are manufactured in high densities, the necessary routing layer structures can become complex and thus expensive if executed in silicon technology. If, additionally, the microstructures are also to be fabricated suspended on membranes, complex thinning processes become necessary to form these often rather fragile membranes. Here, a novel fabrication concept is demonstrated that allows for the fabrication of membrane-suspended microstructures using standard microfabrication techniques directly integrated with printed circuit boards (PCB) by laminating polyimide (PI) films over cavities in the PCB. This results in cost-effective routing layer fabrication and direct compatibility with common electronic component standards such as SMT (surface-mount technology) and THT (through-hole technology). To illustrate the capabilities of the fabrication process, we fabricated an array of membrane suspended microheaters. Individual platinum microheater elements are suspended on PI membranes that are 25
$\mu \text{m}$
thick and 500
$\mu \text{m}$
in diameter. The fabricated PCB carries a
$10\times 10$
array of suspended microheaters on an area of 26mm
$\times\,\,26$
mm. The characterization of the microheater array shows that a yield of 86% functional microheaters was achieved. An individual microheater shows an almost linear heating characteristic at least up to 200°C demonstrating the viability of the technique for creating functional membrane-suspended microstructures on a PCB. [2021-0226]