A 4th-Order 4-Bit Continuous-Time ΔΣ ADC Based on Active–Passive Integrators With a Resistance Feedback DAC

This article reports a fourth-order continuous-time (CT) delta–sigma modulator (DSM) that features a single-amplifier biquad, a passive integrator, and an active integrator. This simplifies the circuit to only two op-amps in comparison to four power-hungry op-amps used in a conventional fourth-order DSM. In addition to improving the power consumption, the proposed design also has more relaxed requirements for the gain–bandwidth product and the loop gain. A 4-bit flash analog-to-digital converter (ADC) and two feedback digital-to-analog converters (DACs) are employed in this design to implement a fully integrated CT DSM. By incorporating the passive network in front of the last active integrator, this design gives a better attenuation at high frequency, which decreases the possibility of instability caused by out-of-band high-frequency signals. The proposed design has a measured bandwidth of 2 MHz with a power consumption of only around 3 mW. The effective number of bits (ENOB) of the proposed CT-DSM is approximately 12.7 bits with a peak signal-to-noise and distortion ratio (SNDR) around 78 dB, and it also exhibits a good Schreier figure of merit on the order of 166 dB compared to the existing state of the art.