A General Framework for Designing 3D Impellers Using Topology Optimization and Additive Manufacturing

Computer Numerical Control (CNC) milling is still today the elective process for the production of single-piece impellers, as it can reliably produce complex geometries, removing the need for additional manufacturing processes. Nevertheless, Additive Manufacturing is winning more and more ground due to its ability to make components of any geometry that cannot be produced using subtractive techniques. As a result, the use of this technology can eventually be seen as the key to develop high-performance rotor components. In this scenario, the design of 3D impellers does not make an exception. Accordingly, the present paper proposes a general framework for engineered re-design and manufacture of 3D impellers installed on centrifugal compressors by exploiting Topology Optimization and Additive Manufacturing's potential. The procedure investigates also the rotoric component's best configuration for both static and dynamic behavior. Finally, the topology-optimized component is produced with AM through the use of suitable materials that can ensure efficient mechanical efficiency to prove the manufacturability of the entire procedure. To validate the proposed framework, the complete re-design of a 3D impeller of a major Italian-based Oil & Gas company is carried out, demonstrating that the re-thinking of the component in terms of Topology Optimization is a straightforward approach to increase the overall performance of the produced rotoric part.