Four-beam Antenna Array with Low Side-lobe for Base Station Application

Multi-beam antenna is an important way to increase the channel capacity of cellular communications. It is available in two ways, one is based on optical methods, such as Luneberg lens and Rotman lens. However, the common problem with this method is that the lens size is too large or difficult to process. Another method is based on beam-forming network composed of coupler and phase shifter, such as Butler matrix. The Butler matrix has been studied for a long time, in the form of microstrip, stripline, or substrate-integrated waveguide. The substrate-integrated waveguide with low insertion loss is mainly used in the higher frequency such as millimeter wave band. The microstrip is mainly used in 4G/5G base stations, suitable for broadband design and process. Low side-lobe level, narrow beams are especially important for multi-beam base station antennas. The traditional Butler matrix is 4 × 4 Butler matrix for 4-beam base stations. However, the traditional Butler matrix can only output equal-amplitude power, with a side-lobe level higher than -13.4 dB. The beam width is too wide due to the few number of antenna. The 4 × 4 Butler Matrix with attenuator can reduce the side-lobe level, but it will increase the insertion loss of the beam-forming network. The 4 × 4 Butler matrix with phase shifter and power divider can form a 4 × 6 Butler matrix, which reduce the beam width beam and side-lobe level. However, for large-angle scanning, not only the side-lobe level, but also the grating-lobe problem caused by the wide-angle scanning and wide antenna spacing needs to be solved. The array with triangle arrangement can reduce the side-lobe and grating-lobe level. A wide-band 4-beam antenna array and beam-forming network for 4G base stations are presented in this paper. Adopting triangular arrangement, the number of antenna in sub-array is increased, and the antenna spacing is reduced, resulting in good side-lobe and grating-lobe level suppression. The output amplitude and phase errors are small over a wide band, with low insertion loss.