Ripple Voltage Injection to Mitigate Limit Cycle in Digitally Controlled Intermediate Bus Architectures

This paper proposes a ripple injection method in a two-stage intermediate bus architecture to overcome the incremental negative-impedance effect in the intermediate bus converter (IBC) induced by the constant power load, which is essentially a tightly regulated point of load (PoL) converter. The proposed method uses the voltage ripple of the intermediate bus in the feedback path for the closed-loop PoL converter while operating the IBC in open loop. The small-signal model is derived and verified using SIMPLIS simulation. The voltage ripple is shown to carry the inductor current information of the PoL converter. Thus, the proposed scheme is expected to retain the superior line regulation of current mode control for the PoL converter even without sensing the inductor current. Load current feed forward can improve the transient response for the PoL converter. Moreover, the load current information is also used to generate the appropriate duty ratio for the IBC during transient recovery. A simple PI controller is used for the PoL converter, which reduces the design complexity using the proposed control scheme. A hardware prototype is made, and the superior performance using the proposed control scheme is experimentally verified.