Minimum Active Switch Requirements for Single-Phase PFC Rectifiers Without Electrolytic Capacitors

Active pulsating power buffering (PPB) function can effectively reduce the twice-line frequency energy storage requirement in a single-phase rectifier. Existing single-phase solutions with active PPB must utilize more than two active switches in their circuits. Compared with conventional single-active-switch solutions without active PPB (e.g., a boost power-factor-correction (PFC) rectifier), the cost of additional semiconductor switches and gate drive circuitry in an active PPB-based rectifier may not be justified for low-power applications. This paper presents a family of single-switch single-phase rectifier with active PPB. Taking advantage of the on-time and off-time of a single switch, the proposed rectifiers are formulated by merging two converters that are duty and frequency controlled. The steady-state characteristics of these converters are analyzed. A step-by-step design procedure is provided, and an active control method for limiting the maximum switching frequency for wide-load-range operation is presented. A 100-W prototype is built for the demonstration of the proposed single-switch rectifier concept. It is envisaged that this concept, when combined with other circuit formulation techniques, e.g., partial power processing, dc-voltage feedback, may lead to new derivatives of single-switch rectifiers with more advanced features.