A Novel Interleaved Tri-State Boost Converter With Lower Ripple and Improved Dynamic Response

In this paper, the design and development of a novel interleaved tri-state boost converter (ITBC), which produces lower ripple and exhibits better dynamic response, is discussed. Boost converters are frequently connected in parallel and operate in an interleaving mode for the reduction of ripple content in source current and in output voltage. In this way, interleaved boost converter (IBC) is conceived, which improves the power handling capabilities and increases the overall system rating. It also has the advantage of reduction of the ripple content in source current and output voltage, but when control-to-output transfer function of IBC is derived under continuous conduction mode of operation, then a right-half-plane (RHP) zero appears in the transfer function. Due to the presence of RHP zero, IBC has nonminimum phase problem, which deteriorates the dynamic performance. The tri-state boost converter (TBC) is the best choice for RHP zero elimination, but due to the extra freewheeling mode, ripple content will also be increased. The proposed converter is a parallel combination of two TBC and operates in an interleaving mode. Therefore, the proposed converter has both of the advantages of TBC and IBC. The performance analyses of ITBC, TBC, and IBC have been studied based on simulation and experimental results. From the comparative analysis, it is observed that ITBC is performed better than other two converters. The ripple comparisons between three converters have also been done. It is found that the ripple content in ITBC is slightly greater than IBC but is less than TBC.