Bent superconducting solenoids for the muon cooling experiment

This report describes some solenoid design work done for the cooling experiment for the muon collider collaboration. This report describes an analysis section of superconducting solenoids that have a center line induction of 3.0 T. The section is bent in the shape of an S. Each bend in the S bends the muon beam one radian (57.3 degrees). The warm bore diameter of the solenoid bent solenoid is 300 to 320 mm. The radius of the bend at the solenoid center line is 1000 mm. This report shows the results of three dimensional field calculations and presents a solenoid design that will include four TPC detectors that are 240 mm in diameter and 550 mm long as well as a 1300 mm long section of 1300 MHz RF cavities. The TPC sections need a solenoid warm bore diameter of about 300 320 mm while RF cavities require a warm bore diameter of 440 mm. The superconducting solenoid design must take into account the varying warm bore diameter requirements for the magnet string yet meet the stringent solenoidal field uniformity requirements within the active volume of the four TPCs.