Analysis and design of connection between flexible PCB and hard PCB for 25 Gb/s optical subassembly module

The rapid development of information and communication technologies has driven the rapid growth of data traffic and the large requirement of high-speed optical transceiver modules. Usually, optical subassemblies through flexible printed circuit boards (PCBs) connect with the hard PCBs to compose as optical transceiver modules. Because of the impedance mismatch of connection between flexible PCB and hard PCB, the operation bandwidth of the module can be limited. In this paper, the design of connection between flexible PCB and hard PCB in optical subassembly modules will be investigated for increasing the operation speed of the module. First, the transmission bandwidth of flexible PCB is analyzed. High-frequency performances of three transmission line structures, micro-strip line, grounded coplanar waveguide, and top ground micro-strip line, are investigated in flexible PCB. High-frequency performances of flexible PCB with different bending types are also investigated. The flexible PCB has been verified to be suitable to use in 25 Gb/s applications. Next, the high-speed transmission performance is analyzed through the connection between flexible PCB and hard PCB, because the impedance mismatch usually occurs at the connection. The ground pads are added near the signal line of flexible PCB, and the ground pads are connected to the ground layer in PCB through ground vias. The anti-pad in hard PCB is added under the signal solder pad. The dip of S21 response can be eliminated by the optimized ground pad. The impedance mismatch can be reduced by the optimized anti-pad, the impedance increases from 40-Ω to 49-Ω at the connection between flexible PCB and hard PCB, and the transmission bandwidth can increase from 16.5 GHz to 23.5 GHz. TO-46 header is a common and low-cost packaging solution for DFB laser and photodiodes. The connection between flexible PCB and TO-46 header is also investigated. While the connection has a gap, the dip of frequency response will occur at lower frequency. While the connection is very close, the bandwidth can be larger than 25 GHz. The flexible PCB, hard PCB, and TO-46 header are combined together, and the 23 GHz transmission bandwidth can be obtained. The 25 Gb/s transmission eye diagram is also measured, and the eye height, rise time, fall time, and Q-factor are 268.14 mV, 13.78 ps, 13.56 ps, and 8.76, respectively. The combined flexible PCB, hard PCB, and TO-46 header are verified to be suitable to apply in 25 Gb/s optical subassembly modules, and will be able to be used in 100G Ethernet.