High gain wideband 2×2 microstrip array antenna using RIS and Fabry Perot Cavity resonator

This paper presents a high gain wide band 2×2 microstrip array antenna. The microstrip array antenna (MSA) is fabricated on inexpensive FR4 substrate and placed 1mm above ground plane to improve the bandwidth and efficiency of the antenna. A reactive impedance surface (RIS) consisting of 13×13 array of 4 mm square patches with inter-element spacing of 1 mm is fabricated on the bottom side of FR4 substrate. RIS reduces the coupling between the ground plane and MSA array and therefore increases the efficiency of antenna. It enhances the bandwidth and gain of the antenna. RIS also helps in reduction of SLL and cross polarization. This MSA array with RIS is place in a Fabry Perot cavity (FPC) resonator to enhance the gain of the antenna. 2×2 and 4×4 array of square parasitic patches are fed by MSA array fabricated on a FR4 superstrate which forms the partially reflecting surface of FPC. The FR4 superstrate layer is supported with help of dielectric rods at the edges with air at about λ0/2 from ground plane. A microstrip feed line network is designed and the printed MSA array is fed by a 50 Ω coaxial probe. The VSWR is <; 2 is obtained over 5.725-6.4 GHz, which covers 5.725-5.875 GHz ISM WLAN frequency band and 5.9-6.4 GHz satellite uplink C band. The antenna gain increases from 12 dB to 15.8 dB as 4×4 square parasitic patches are fabricated on superstrate layer. The gain variation is less than 2 dB over the entire band. The antenna structure provides SLL and cross polarization less than -2ο dB, front to back lobe ratio higher than 20 dB and more than 70 % antenna efficiency. A prototype structure is realized and tested. The measured results satisfy with the simulation results. The antenna can be a suitable candidate for access point, satellite communication, mobile base station antenna and terrestrial communication system.