Performance Analysis of a Two-Diode model of PV cell for PV based generation in MATLAB

The increase in concern for carbon emission and reduction in natural resources for conventional power generation, the renewable energy based generation such as Wind, Photovoltaic (PV), and Fuel cell has gained importance. Out of which the PV based generation has gained significance due to availability of abundant sunlight. As the Solar power conversion is a low efficient conversion process, accurate and reliable, modeling of solar cell is important. Due to the non-linear nature of diode based PV model, the accurate design of PV cell is a difficult task. A built-in model of PV cell is available in Simscape, Simelectronics library, Matlab. The equivalent circuit parameters have to be computed from data sheet and incorporated into the model. However it acts as a stiff source when implemented with a MPPT controller. Henceforth, to overcome this drawback, in this paper a two-diode model of PV cell is implemented in Matlab Simulink with reduced four required parameters along with similar configuration of the built-in model. This model allows incorporation of MPPT controller. The I–V and P-V characteristics of these two models are investigated under different insolation levels. A PV based generation system feeding a DC load is designed and investigated using these two models and further implemented with MPPT based on P&O technique.