Evaluation of breakdown characteristics of N2 gas for non-standard lightning impulse waveforms - breakdown characteristics under single-frequency oscillation waveforms and with bias voltages

SF₆ gas, an insulation medium used for gas insulated switchgear (GIS), has a high global warming potential, hence the search for an effective alternative is required from an environmental perspective. As one of its potential alternatives, the authors are focusing on N2 gas, which has relatively good insulation characteristics among natural gases and a low environmental impact. However, to use this N2 gas for actual GIS, the insulation characteristics for actual overvoltage waveforms generated in the field (non-standard lightning impulse waveforms; non-standard-LIWs) must be obtained. The present study, with single-frequency oscillation waveforms as a representative basis among non-standard LIWs, experimentally obtained the insulation characteristics of an N₂ gas gap by changing the frequency and the damping factor. Consequently, the breakdown voltage (BDV) was lower for the negative polarity under a quasi-uniform electric field, hence the conclusion that it was reasonable to conduct experiments using negative polarity waveforms in order to discuss the dielectric strength. In addition, even if the frequency and damping factor changed, the BDV remained relatively constant, and that is consistently higher than that for the standard lightning impulse waveforms (standard-LIWs) at a level of 1.14 to 1.24 times. As a result, it was also confirmed for GIS using N₂ gas that the insulation specification could be rationalized by about 20% by converting lightning impulse waveforms from non-standard to equivalent standard-LIWs of 1.2/50 μs. Furthermore, insulation characteristics were obtained under the pattern in which a disconnector switching surges are superposed on residual dc elements generated through the operation of disconnectors (bias voltages). Consequently, the bias voltage had only a minor influence on the insulation characteristics and it emerged that insulation characteristics were likely to be evaluated using a single polarity waveform.