Investigations of two-stage-pseudospark switches for high-current applications

To avoid the lowering of the holdoff voltage due to the electrode erosion in one stage high current pseudospark switches (PSS), a two stage PSS with no axial aperture in the intermediate electrode was tested. For investigations a pulse generator was used generating peak currents up to 120 kA at a maximum voltage of 30 kV with a period length of 5 /spl mu/s of a weakly damped sine wave with 90% current reversal. In comparison with a one stage PSS the breakdown characteristic was shifted to higher pressure. With a free floating intermediate electrode, the device could not be triggered, however, with additional capacities of a few nF between the three electrodes the discharge was ignited. The discharge in the second gap is triggered by the pseudospark discharge in the cathode gap, discharging the auxiliary capacities. Simultaneously, observation of both gaps with fast shutter photography showed an independent movement of the discharges in the two gaps. In the cathode gap as current increases, the discharge moves away from the center to the plane electrode surface as has been observed in the one stage PSS. However, in the anode gap the discharge moves away from the center after a contraction to the center. The two discharges are transmitted to metal vapor arc type discharges as the erosion patterns prove. With this kind of a two stage PSS holdoff voltages exceeding 35 kV would be possible. The characteristic switch data, i.e., delay and jitter, are nearly equal to a one stage PSS.<>