Transient Behavior of the Second Fusillo Subscale Curved CCT Magnet

The Fusillo project at CERN aims to design and build a demonstrator magnet with multi-harmonic corrected fields in a 90°, curved, Canted-Cosine-Theta magnet. Two subscale magnets are built with 30° bending, about 1/30 of the demonstrator conductor length, and increased current to reach coil stresses equivalent to those of the demonstrator. These magnets enable qualification of the technology developments, fabrication methods, winding and assembly procedures, magnetic and quench protection design and measurement setups. The second Fusillo subscale magnet had dedicated instrumentation, including temperature sensors, a heater on the aluminium formers, and a set of sensing coils positioned in the curved bore. The magnet voltage and current were also measured. A specific powering sequence was applied to the magnet, including forced energy extractions. The eddy currents and heat propagation in the formers and the windings are simulated in three dimensions. A cooperative simulation approach was used, which involves tools developed at CERN as part of the STEAM framework: FiQuS, a finite element-based tool, and LEDET, a finite difference-based tool. The measurement results are compared with simulations, and the key aspects of the magnet transient behaviour are discussed. The simulation model inputs are refined using the measurement results, and the methodology for doing this is presented.