Influence of Critical Current Defect on Operation, Quench Detection and Protection of a Conduction-Cooled Pancake REBCO Coil

High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a three-dimensional (3D) coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H− φ formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current can be varied along the CC length. The effect of a single defect specified as a reduction of the critical current along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The critical current and length of the defect that results in a thermal runaway are analyzed in terms of defect location in the coil. These defect locations are compared in terms of the voltage signal available for quench detection and the implications are discussed.