Unraveling the Properties of Interdigital Electrode-based γ-In2Se3 Photodetectors for Optimal Performance

We successfully deposited In2Se3 films on the interdigital electrode (IDE) substrates using the RF-magnetron sputtering method with optimized parameters. The formation of high-quality γ-In
₂
Se
₃
using XRD, Raman spectroscopy, XPS, FE-SEM, and EDS. Subsequently, we fabricated γ-In
₂
Se
₃
-based photodetectors on ITO-coated IDE using optimized parameters. The detailed investigation focused on the influence of IDE spacing, bias voltage, and light intensity on the photodetector properties. The photodetector fabricated with an IDE spacing of 335 μm exhibited outstanding properties, including the highest photoresponsivity of 14.8 μA/W and detectivity of 31.3x10
⁷
Jones. It also demonstrated a fast rise time of 99 ms and a decay time of 61 ms. In the bias voltage variation study, the γ-In
₂
Se
₃
-based photodetectors exhibited a linear relationship between the change in current and the bias potential, indicating the formation of ohmic contact between γ-In
₂
Se
₃
and ITO electrodes. Examining light intensity photoresponse, we varied the power density of light from 5 mW/cm
²
to 30 mW/cm
²
. We observed a direct proportionality between the generated photocurrent and the incident light intensity. However, at higher light intensities, there was a decrease in photodetectivity from 3.97x10
⁸
Jones to 1.16x10
⁸
Jones and a reduction in photoresponsivity from 33.36 μA/W to 9.73 μA/W for the γ-In
₂
Se
₃
-based photodetectors. In conclusion, the photodetector properties of γ-In
₂
Se
₃
-based devices are critically influenced by interdigital electrode spacing, bias voltage, and light intensity.