Reconfigurable Distributed Antennas and Reflecting Surface: A New Architecture for Wireless Communications

Distributed Antenna Systems (DASs) employ multiple antenna arrays in remote radio units to achieve highly directional transmission and provide great coverage performance for future-generation networks. However, the utilization of fully digital or hybrid active antenna arrays results in a significant increase in hardware costs and power consumption for DAS. To address these issues, integrating DAS with Reconfigurable Intelligent Surfaces (RIS) offers a viable approach to ensure coverage and transmission performance while maintaining low hardware costs and power consumption. To incorporate the merits of RIS into the DAS from practical consideration, a novel architecture of “Reconfigurable Distributed Antennas and Reflecting Surfaces (RDARS)” is proposed in this paper. Specifically, based on the design of the additional direct-through state together with the existing high-quality fronthaul link, any element of the RDARS can be dynamically programmed to connect with the base station (BS) via fibers and perform the
connected mode
as remote distributed antennas of the BS to receive or transmit signals. Additionally, RDARS also inherits the low-cost and low-energy-consumption benefits of fully passive RISs by default configuring the elements as passive to perform the
reflection mode
. As a result, RDARS encompasses both DAS and RIS as special cases, offering flexible control over the trade-off between
distribution gain
and
reflection gain
to enhance performance. To unveil the potential of such architecture, the ergodic achievable rate under the RDARS architecture is analyzed and closed-form expression with meaningful insights is derived. The theoretical analysis proves that the RDARS can achieve a higher achievable rate than both DAS and fully passive RIS with the passive beamforming gain provided by elements acting
reflection mode
while combating the “multiplicative fading” suffered by RISs through the
connected mode
performed at the RDARS. Simulation results also demonstrate the superiority of the RDARS architecture over DAS and passive RIS-aided systems and its flexible trade-off between performance and cost. To further validate the feasibility and effectiveness, an RDARS prototype with 256 elements is built for real experiments. Experimental results show that the RDARS-aided system with only one element operating in
connected mode
can achieve an additional 21% and 170% throughput improvement over DAS and RIS-aided systems, respectively.