Rapid Sintering of Inkjet Printed Cu Complex Inks Using Laser in Air

Cu complex inks offer a facile and cost-effective alternative to commercial nanoparticle inks for printed electronics application. Cu complex inks are prepared by mixing Cu formate tetrahydrate (metal precursor) with amino-2-propanol (complexing agent) in a molar ratio of 1:2. A carrier solvent consisting of ethanol and ethylene glycol is then added to help adjust the rheological properties of the ink for printing purpose. The Cu complex ink having a viscosity of 12 mPa.s is then inkjet printed onto a polyimide substrate (thickness: 125 µm). After printing 10 layers, the ink is pre-dried under air at 100°C for 5 minutes followed by sintering using an IR laser (942 nm) to enable rapid thermal decomposition of the Cu formate. After sintering using a 100 W line beam laser scanned at 3 mm/sec under air; a contiguous and homogenous Cu metallic trace is formed with a minimum bulk resistivity of 4.8 µΩcm(2.84 times of bulk Cu). The laser sintered trace exhibited a highly compact and homogenous sintered structure after thermal decomposition compared to the conventional oven sintering process. Th result is remarkable and proves the importance of faster decomposition process. In contrast, sintering the same trace using slow ramp rate within the traditional oven sintering pr process, it is observed that a Cu metallic trace is formed with particles in the range of 2–5 urn that are sparsely distributed due to low metal content of Cu complex inks (< 1 0 metal wt. %). Due to sparse distribution of particles, a low bulk resistivity value of 102 µΩcmis obtained.