Direct Conversion of Hybrid Precoding and Combining From Full Array Architecture to Subarray Architecture for mmWave MIMO Systems

Hybrid precoding and combining for millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems with subarray (SA) architecture is a promising technology for 6G because of their low complexity, cost, and power consumption compared to the full array (FA) architecture. This paper proposes an iterative algorithm for designing hybrid precoding and combining for the SA architecture. It is called direct conversion of iterative hybrid precoding and combining from FA to SA (DCIFS). The proposed algorithm involves an iterative process that begins by designing a hybrid precoding and combining matrix for the FA structure and then converts it into an SA matrix by setting certain entries to zero while achieving better performance. It does not depend on the antenna array geometry, unlike other techniques such as the orthogonal matching pursuit (OMP) hybrid precoding and combining approach. We investigate the proposed algorithm with two scenarios. In the first scenario, we use the proposed DCIFS scheme only at the base station (BS) and the iterative FA hybrid scheme at the mobile station (MS), whereas in the second, we use the proposed DCIFS scheme at both the BS and the MS. Simulation results demonstrate that the proposed design approach achieves a spectral efficiency comparable to that of the FA hybrid design counterpart, especially for a large system, while maintaining low complexity. For example, when SNR = 0 dB and the number of transmitted streams (
$N_{s}$
) = 2, the proposed algorithm provides about 1.5 bps/Hz spectral efficiency gain compared to the OMP hybrid design for the first scenario. Moreover, when the number of iterations is low and the number of BS antenna and
$N_{s}$
is high, the proposed approach outperforms the conventional SA hybrid design in terms of spectral efficiency with the same hardware complexity.