Efficient Integrated Multimode Amplifiers for Scalable Long-Haul SDM Transmission

Scaling up cable capacity in a power- and cost-efficient manner is a goal of spatial-division multiplexing (SDM) in long-haul optical communication systems. Integration is a key to scaling SDM beyond the parallel single-mode fiber paradigm. Multicore or multimode fiber systems promise higher integration, but native multicore or multimode amplifiers pose challenges in efficient coupling of pump light into the amplifier, and in control of mode-dependent gain (MDG). We propose an integrated multimode amplifier design for signals in six spatial modes (12 spatial and polarization modes) that relies on excitation of only four pump spatial modes at 980 nm. Simulations of an exemplary amplifier predict a relatively flat gain above 10 dB, noise figure below 5 dB, and MDG standard deviation below 0.1 dB over the C-band (1530–1565 nm), with a power-conversion efficiency close to 30%. Key design features include a graded-index multimode fiber amplifier with optimized ring erbium doping profile, length and pump mode powers; and a cascade of wavelength- and mode-selective couplers that efficiently couples four pump diodes to four pump modes, while passing signal modes with minimal loss. Our design approach, which uses fewer pump diodes per signal mode than parallel single-mode systems, may provide an option for efficient, economical scaling of SDM long-haul systems.