Application of Al/PI composite bumps to COG bonding process

This work demonstrates the probing, testability and applicability of Al/PI (aluminum/polyimide) composite bumps to the chip on-glass (COG) bonding process for liquid crystal display (LCD) driver chip packaging. The experimental results showed that the thickness of Al overlayer on PI core of the bump, the location of pin contact, and the bump configuration affect bump probing testability. The bump with type IV configuration prepared in this work exhibited excellent probing testability when its Al overlayer thickness exceeded 0.8 /spl mu/m. We further employed Taguchi method to identify the optimum COG bonding parameters for the Al/PI composite bump. The four bonding parameters, bonding temperature, bonding time, bonding pressure and thickness of Al overlayer are identified as 180/spl deg/ C, 10 s, 800 kgf/cm/sup 2/ and 1.4 /spl mu/m, respectively. The optimum bonding condition was applied to subsequent COG bonding experiments on glass substrates containing Al pads or indium tin oxide (ITO) pads. From the results of resistance measurement along with a series of reliability tests, Al pad is found to be a good substrate bonding pad for Al/PI bump to COG process. Excellent contact quality was observed when the bumps had Al overlayer thickness over 1.1 /spl mu/m. As to the COG specimens with substrate containing ITO pads, high joint resistance suggested that further contact quality refinement is necessary to realize their application to COG process.