A 2-dimensional MSGC-based imaging detector for X-rays

The development and testing of a two-dimensional (2-D) prototype detector based on a microstrip gas chamber (MSGC) are reported. The second coordinate is obtained by utilising a plane of wires as pick up electrodes. The detector is operated with the wire plane at such a potential so as not to induce any gain around the wires. This means that the high tolerances normally associated with wire planes in multiwire proportional counters are not necessary, making the manufacture and repair of such a device relatively easier. The detector comprises of 48 individually instrumented channels in both X (MSGC strips) and Y (transverse wire plane). A specially designed encoding module has been constructed which feeds digital addresses for each event to the ISIS data acquisition electronics (DAE) system. (ISIS is the spallation neutron source at the Rutherford Appleton Laboratory.) An intrinsic detector resolution of /spl sim/0.5 mm full-width at half-maximum (FWHM) has been measured for both dimensions which is degraded slightly by the digital resolution for the overall system. This readout method is shown to be very tolerant of a poor signal-to-noise ratio in the readout channels (unlike traditional analogue wire chamber readout systems) and permits the operation of the MSGC at moderate avalanche gains (/spl sim/1000) which helps to maximize the rate and lifetime performance of the detector as well as permitting data capture rates in the MHz range.