By Topic

# IEEE Transactions on Industrial Electronics

## Filter Results

Displaying Results 1 - 25 of 71
• ### Table of Contents

Publication Year: 2014, Page(s):C1 - 3798
| PDF (57 KB)
• ### IEEE Transactions on Industrial Electronics publication information

Publication Year: 2014, Page(s): C2
| PDF (141 KB)
• ### An Active Harmonic Filter Based on One-Cycle Control

Publication Year: 2014, Page(s):3799 - 3809
Cited by:  Papers (16)
| | PDF (1399 KB) | HTML

The widespread usage of load compensators for carrying out harmonic and reactive power compensation is constrained by cost and poor efficiency due to switching losses. Hence, it is customary to employ active harmonic filters for harmonic compensation only, while traditional methods comprising of thyristor-switched capacitors are used to carry out reactive power compensation. Load compensators base... View full abstract»

• ### Control Strategy for Current Harmonic Programmed AC Active Electronic Power Loads

Publication Year: 2014, Page(s):3810 - 3822
Cited by:  Papers (5)
| | PDF (2286 KB) | HTML

Alternating current (ac) active electronic loads (AELs) based on pulsewidth modulation (PWM) converters, capable of emulating nonlinear loads, require effective current control techniques and power stages. These two aspects of an AEL are interdependent mainly due to the presence of electromagnetic compatibility filters to reduce electromagnetic emissions. However, the filter components affect the ... View full abstract»

• ### Design Considerations and Fully Digital Implementation of 400-Hz Active Power Filter for Aircraft Applications

Publication Year: 2014, Page(s):3823 - 3834
Cited by:  Papers (7)
| | PDF (2340 KB) | HTML

This paper proposes the key design guidelines for a fully digitally controlled 400-Hz active power filter (APF), in which the circuit parameter selections and control design remarkably affect the performance of the APF. Detailed design considerations, including APF grid-connected inductance, line inductance, dc bus capacitance, and digital signal processor control implementation, were presented to... View full abstract»

• ### AC Voltage Sag/Swell Compensator Based on Three-Phase Hybrid Transformer With Buck-Boost Matrix-Reactance Chopper

Publication Year: 2014, Page(s):3835 - 3846
Cited by:  Papers (26)
| | PDF (1633 KB) | HTML

The parameters of electrical energy such as voltage amplitude are very important, particularly from the viewpoint of the final consumer and sensitive loads connected to the grid. The dynamic states in the power grid-deep voltage sags and swells-might cause faults and defects in sensitive loads. This paper deals with a three-phase hybrid transformer (HT) without dc energy storage to compensate volt... View full abstract»

• ### Vienna Rectifier With Power Quality Added Function

Publication Year: 2014, Page(s):3847 - 3856
Cited by:  Papers (18)
| | PDF (885 KB) | HTML

The aim of this paper is to introduce power quality added function to the standard Vienna rectifier in order to compensate reactive power and to cancel current-type harmonics drawn by nonlinear loads connected to the same point of common coupling. A theoretical investigation that demonstrates the ability of such topology to compensate harmonics and limited reactive power is first presented. Then, ... View full abstract»

• ### Artificial-Neural-Network-Based Phase-Locking Scheme for Active Power Filters

Publication Year: 2014, Page(s):3857 - 3866
Cited by:  Papers (26)
| | PDF (2222 KB) | HTML

This paper presents a phase-locking control scheme based on artificial neural networks (ANNs) for active power filters (APFs). The proposed phase locking is achieved by estimating the fundamental supply frequency and by generating a phase-locking signal. The nonlinear-least-squares-based approach is modified to estimate the supply frequency. To improve the accuracy of frequency estimation, when th... View full abstract»

• ### A Comparative Study of Synchronous Current Control Schemes Based on FCS-MPC and PI-PWM for a Two-Motor Three-Phase Drive

Publication Year: 2014, Page(s):3867 - 3878
Cited by:  Papers (25)
| | PDF (1257 KB) | HTML

A two-motor drive, supplied by a five-leg inverter, is considered in this paper. The independent control of machines with full dc-bus voltage utilization is typically achieved using an existing pulsewidth modulation (PWM) technique in conjunction with field-oriented control, based on PI current control. However, model predictive control (MPC), based on a finite number of control inputs [finite-con... View full abstract»

• ### A D-$\Sigma$ Digital Control for Three-Phase Inverter to Achieve Active and Reactive Power Injection

Publication Year: 2014, Page(s):3879 - 3890
Cited by:  Papers (11)
| | PDF (2529 KB) | HTML

This paper presents a division-summation (D- Σ) digital control for a three-phase inverter to achieve active and reactive power injection to the ac grid. The proposed D- Σ approach summarizes the inductor-current variations over one switching cycle to derive control laws directly, which can overcome the limitation of d- q transformation. The inverter with this control can achieve var... View full abstract»

• ### Space-Vector-Based Synchronized Three-Level Discontinuous PWM for Medium-Voltage High-Power VSI

Publication Year: 2014, Page(s):3891 - 3901
Cited by:  Papers (21)
| | PDF (2448 KB) | HTML

The high-power voltage source inverters are switched at low frequency to reduce the losses in the inverter. The discontinuous pulsewidth-modulation (PWM) sequences reduce the switching frequency to two-thirds compared to the conventional continuous PWM sequences. At low switching frequency, the output will be rich in harmonics, and synchronization is a must to avoid subharmonics. This paper presen... View full abstract»

• ### Parameter Design and Static Performance of Dual Stator-Winding Induction Generator Variable Frequency AC Generating System With Inductive and Capacitive Loads

Publication Year: 2014, Page(s):3902 - 3914
Cited by:  Papers (9)
| | PDF (2224 KB) | HTML

In this paper, the design methods of the auxiliary excitation capacitors and the filter inductances are investigated for the dual stator-winding induction generator (DWIG) variable frequency ac (VFAC) generating system with inductive and capacitive loads, and the system static performance is presented as well. For this generating system, the proper selection of the auxiliary excitation capacitors ... View full abstract»

• ### Simple Low-Speed Sensorless Dual DTC for Double Fed Induction Machine Drive

Publication Year: 2014, Page(s):3915 - 3922
Cited by:  Papers (11)
| | PDF (2410 KB) | HTML

In this paper, a doubly fed induction machine (DFIM) operating in motor mode and supplied by two voltage source inverters-in stator and rotor sides-is presented. The aim is to analyze the sensorless rotor position operation of a dual direct torque control (DDTC) of the DFIM. This paper presents a sensorless DDTC for a DFIM speed drive in order to guarantee the static and dynamic system performance... View full abstract»

• ### Temperature Calculation for Tubular Linear Motor by the Combination of Thermal Circuit and Temperature Field Method Considering the Linear Motion of Air Gap

Publication Year: 2014, Page(s):3923 - 3931
Cited by:  Papers (8)
| | PDF (1010 KB) | HTML

The air gap of tubular linear motors moves linearly, causing heat transfer states of the motor to alternate repeatedly. Thus, the heat transfer coefficients of the mover inner surface and the stator outer surface vary constantly. In this paper, the combination model of the thermal circuit and temperature field is established to calculate the transient temperature rise of a tubular linear motor wit... View full abstract»

• ### A New General Topology for Cascaded Multilevel Inverters With Reduced Number of Components Based on Developed H-Bridge

Publication Year: 2014, Page(s):3932 - 3939
Cited by:  Papers (60)
| | PDF (1278 KB) | HTML

In this paper, a new general cascaded multilevel inverter using developed H-bridges is proposed. The proposed topology requires a lesser number of dc voltage sources and power switches and consists of lower blocking voltage on switches, which results in decreased complexity and total cost of the inverter. These abilities obtained within comparing the proposed topology with the conventional topolog... View full abstract»

• ### Active Common-Mode Filter for Ground Leakage Current Reduction in Grid-Connected PV Converters Operating With Arbitrary Power Factor

Publication Year: 2014, Page(s):3940 - 3950
Cited by:  Papers (31)
| | PDF (1310 KB) | HTML

This paper proposes a solution for reducing the ground leakage current in transformerless single-phase grid-connected photovoltaic converters. This is obtained with the introduction of an active common-mode filter able to compensate for variations of the output common-mode voltage of the power converter. The active common-mode filter is applied to a widespread and efficient full-bridge driven by a... View full abstract»

• ### A Nine-Level Grid-Connected Converter Topology for Single-Phase Transformerless PV Systems

Publication Year: 2014, Page(s):3951 - 3960
Cited by:  Papers (52)
| | PDF (2452 KB) | HTML

This paper presents a single-phase transformerless grid-connected photovoltaic converter based on two cascaded full bridges with different dc-link voltages. The converter can synthesize up to nine voltage levels with a single dc bus, since one of the full bridges is supplied by a flying capacitor. The multilevel output reduces harmonic distortion and electromagnetic interference. A suitable switch... View full abstract»

• ### Combined Bidirectional Buck–Boost DC–DC Chopper-Mode Inverters With High-Frequency Link

Publication Year: 2014, Page(s):3961 - 3968
| | PDF (928 KB) | HTML

A circuit configuration, a circuit topological family, a buck-mode active clamped circuit, and an instantaneous output voltage feedback control strategy of combined bidirectional buck-boost dc-dc chopper-mode inverter with high-frequency (HF) link (HFL) were proposed and fully investigated in this paper. The steady principle characteristic and the design criteria for the key circuit parameters wer... View full abstract»

• ### Use of Frequency-Selective Surface for Suppressing Radio-Frequency Interference from Wireless Charging Pads

Publication Year: 2014, Page(s):3969 - 3977
Cited by:  Papers (12)
| | PDF (2389 KB) | HTML

Wireless charging is an emerging technology that involves multidisciplinary research. Power converters driving the planar wireless charging pads generate radio-frequency interference (RFI) that can degrade the signal transmission and reception of portable communication devices such as mobile phones. In this paper, the practical evidence of the RFI arising from the switching electronics in a wirele... View full abstract»

• ### Half-Bridge Integrated ZVS Full-Bridge Converter With Reduced Conduction Loss for Electric Vehicle Battery Chargers

Publication Year: 2014, Page(s):3978 - 3988
Cited by:  Papers (25)
| | PDF (2009 KB) | HTML

A half-bridge integrated zero-voltage-switching (ZVS) full-bridge converter with reduced conduction loss for battery on-board chargers in electric vehicles (EVs) or plug-in hybrid electric vehicles (PHEVs) is proposed in this paper. The proposed converter features a reduction in primary-conduction loss and a lower secondary-voltage stress. In addition, the proposed converter has the most favorable... View full abstract»

• ### A Chain Structure of Switched Capacitor for Improved Cell Balancing Speed of Lithium-Ion Batteries

Publication Year: 2014, Page(s):3989 - 3999
Cited by:  Papers (49)
| | PDF (3250 KB) | HTML

Among various active cell balancing circuits, a switched capacitor circuit is promising because it can be implemented with low cost and small size. However, when the switched capacitor is applied in the lithium-ion battery, cell balancing speed is generally slow when the number of batteries is high. Therefore, this paper proposes the chain structure of the switched capacitor to increase balancing ... View full abstract»

• ### A Novel Design and Optimization Method of an $LCL$ Filter for a Shunt Active Power Filter

Publication Year: 2014, Page(s):4000 - 4010
Cited by:  Papers (41)
| | PDF (1620 KB) | HTML

Compared with the L filter, the LCL filter is more suitable for high-power low-switching-frequency applications due to its better attenuation characteristics on high frequencies. However, the parameter design for the LCL filter is more complex since both the inhibiting effect of the high-frequency harmonic current and the influence to the controller response performance of the converter should be ... View full abstract»

• ### Level- and Phase-Shifted PWM for Seven-Level Switched-Capacitor Inverter Using Series/Parallel Conversion

Publication Year: 2014, Page(s):4011 - 4021
Cited by:  Papers (17)
| | PDF (1502 KB) | HTML

This paper presents a comparison of two modulation methods for the seven-level switched-capacitor (SC) inverter using series/parallel conversion (SCISPC). The SCISPC is a multilevel inverter which has the less number of switching devices than the conventional multilevel inverters. The level-shifted pulsewidth modulation (PWM) (LS-PWM) was applied to the seven-level SCISPC in the previous research.... View full abstract»

• ### On Optimizing the Aerodynamic Load Acting on the Turbine Shaft of PMSG-Based Direct-Drive Wind Energy Conversion System

Publication Year: 2014, Page(s):4022 - 4031
Cited by:  Papers (19)
| | PDF (2298 KB) | HTML

The blade's rotational sampling to the spatial distributed wind velocities will induce 3P oscillating aerodynamic torque during the wind energy generation process. This causes the turbine drive train bare high aerodynamic load because the generator is driven by this aerodynamic torque through it. Moreover, the system's inherent resonant mode will be also induced by the aerodynamic load, causing fa... View full abstract»

• ### Implementation of Hierarchical Control in DC Microgrids

Publication Year: 2014, Page(s):4032 - 4042
Cited by:  Papers (62)
| | PDF (1586 KB) | HTML

DC microgrids are becoming popular in low-voltage distribution systems due to the better compatibility with photovoltaic panels, electric vehicles, and DC loads. This paper presents a practical dc microgrid developed in the Water and Energy Research Laboratory (WERL) in the Nanyang University of Technology, Singapore. The coordination control among multiple dc sources and energy storages is implem... View full abstract»

## Aims & Scope

IEEE Transactions on Industrial Electronics encompasses the applications of electronics, controls and communications, instrumentation and computational intelligence for the enhancement of industrial and manufacturing systems and processes.

Full Aims & Scope

## Meet Our Editors

Editor-in-Chief
Leopoldo Garcia Franquelo
Escuela Superior de Ingenieros
Universidad de Sevilla
Camino de los Descubrimientos s/n
41092 Sevilla, Spain
lgfranquelo@ieee.org
Phone: +34 954 48 73 65