# IEEE Transactions on Microwave Theory and Techniques

## Filter Results

Displaying Results 1 - 25 of 49

Publication Year: 2010, Page(s):C1 - C4
| |PDF (57 KB)
• ### IEEE Transactions on Microwave Theory and Techniques publication information

Publication Year: 2010, Page(s): C2
| |PDF (44 KB)
• ### $N$ -Port T-Networks and Topologically Symmetric Circuit Theory

Publication Year: 2010, Page(s):705 - 709
Cited by:  Papers (11)
| |PDF (227 KB) | HTML

N-port Pi-networks can be extracted directly from Y-parameters. Likewise, two-port T-networks can be extracted directly from two-port Z-parameters. However, it appears that N-port T-networks have not been previously identified for N > 2, a strange topological asymmetry in circuit theory. We introduce the general N-port T-network and illustrate applicati... View full abstract»

• ### Nonlinear Dispersive Modeling of Electron Devices Oriented to GaN Power Amplifier Design

Publication Year: 2010, Page(s):710 - 718
Cited by:  Papers (63)
| |PDF (1509 KB) | HTML

This paper presents a new modeling approach accounting for the nonlinear description of low-frequency dispersive effects (due to thermal phenomena and traps) affecting electron devices. The theoretical formulation is quite general and includes as particular cases different models proposed in the literature. A large set of experimental results, oriented to microwave GaN power amplifier design, is p... View full abstract»

• ### Accurate EM-Based Modeling of Cascode FETs

Publication Year: 2010, Page(s):719 - 729
Cited by:  Papers (12)
| |PDF (1669 KB) | HTML

Cascode field-effect transistors (FETs) are widely used in the design of monolithic microwave integrated circuits (MMICs), owing to their almost unilateral and broadband behavior. However, since a dedicated model of the cell is rarely provided by foundries, a suboptimal description built by replicating the standard foundry model for both the common source and common gate device is often adopted. T... View full abstract»

• ### Joint Mitigation of Power Amplifier and I/Q Modulator Impairments in Broadband Direct-Conversion Transmitters

Publication Year: 2010, Page(s):730 - 739
Cited by:  Papers (87)
| |PDF (790 KB) | HTML

In this paper, we present a novel digital predistorter structure for joint mitigation of frequency-dependent power amplifier (PA) and in-phase and quadrature (I/Q) modulator impairments in direct-conversion radio transmitters. The predistorter is based on an extended parallel Hammerstein structure, yielding a predistorter that is fully linear in the parameters. In the parameter estimation stage, t... View full abstract»

• ### Comprehensive Noise Characterization and Modeling for 65-nm MOSFETs for Millimeter-Wave Applications

Publication Year: 2010, Page(s):740 - 746
Cited by:  Papers (14)
| |PDF (1037 KB) | HTML

Using an external tuner-based method, this paper demonstrates a complete millimeter-wave noise characterization and modeling up to 60 GHz for 65-nm MOSFETs for the first time. Due to channel length modulation, the channel noise continues to increase and remains the most important noise source in the millimeter-wave band. Our experimental results further show that, with the downscaling of channel l... View full abstract»

• ### A CMOS Integrated Analog Pulse Compressor for MIMO Radar Applications

Publication Year: 2010, Page(s):747 - 756
Cited by:  Papers (8)
| |PDF (2775 KB) | HTML

Conventional radar pulse compressors use either surface acoustic wave devices or fast convolution processing, but both solutions have significant drawbacks. To overcome these drawbacks, an integrated analog pulse compressor for a multiple-input multiple-output (MIMO) radar has been developed with an 0.18-??m CMOS process using an arbitrary waveform generator, analog correlators, and analog-to-digi... View full abstract»

• ### Bit Error Rate Performance Enhancement of a Retrodirective Array Over a Conventional Fixed Beam Array in a Dynamic Multipath Environment

Publication Year: 2010, Page(s):757 - 763
Cited by:  Papers (9)
| |PDF (1461 KB) | HTML

In this paper, we provide experimental evidence to show that enhanced bit error rate (BER) performance is possible using a retrodirective array operating in a dynamically varying multipath environment. The operation of such a system will be compared to that obtained by a conventional nonretrodirective array. The ability of the array to recover amplitude shift keyed encoded data transmitted from a ... View full abstract»

• ### Design and Analysis of Swapped Port Coupler and Its Application in a Miniaturized Butler Matrix

Publication Year: 2010, Page(s):764 - 770
Cited by:  Papers (23)
| |PDF (1154 KB) | HTML

This paper presents a novel size reduction technique for designing a Butler matrix using a new type of coupler. This coupler is half the length of a conventional coupler and has a swapped port characteristic wherein the locations of the isolation and coupled ports are switched. These features make the new coupler, called the "swapped port coupler," effective for reducing the size of the Butler mat... View full abstract»

• ### A $Ku$ -Band Two-Antenna Four-Simultaneous Beams SiGe BiCMOS Phased Array Receiver

Publication Year: 2010, Page(s):771 - 780
Cited by:  Papers (27)
| |PDF (1585 KB) | HTML

This paper presents a Ku-band SiGe BiCMOS phased array receive chip capable of forming four-simultaneous beams from two antenna inputs. The design is based on the all-RF architecture with 4-bit active phase shifters and 4-bit variable gain amplifiers in each channel. The four-beam chip results in a gain of 4-6 dB per channel at 13-15 GHz, a noise figure of 10-11 dB, a worst case input P1 dB View full abstract»

• ### On the Recovery Time of Highly Robust Low-Noise Amplifiers

Publication Year: 2010, Page(s):781 - 787
Cited by:  Papers (10)
| |PDF (509 KB) | HTML

Recently, GaN-based low-noise amplifiers (LNAs) were shown to provide high ruggedness together with low noise figure. Since no limiter is required to protect the input, these LNAs allow for simplified receiver architectures. This paper presents an in-depth analysis of the recovery time of a highly rugged LNA. Recovery time is measured in the time domain, and an analytical approximation is develope... View full abstract»

• ### Efficiency Enhancement of Class-E Power Amplifiers at Low Drain Voltage

Publication Year: 2010, Page(s):788 - 794
Cited by:  Papers (3)
| |PDF (531 KB) | HTML

In this paper, the output power, phase response, and drain efficiency of a class-E power amplifier with shunt capacitance, composed of nonlinear and linear capacitance, is analyzed to manifest the cause of efficiency degradation at low drain dc supply voltage (V dc). Analysis also shows that the drain efficiency at low V dc can be improved by reducing the on-dut... View full abstract»

• ### Low-Noise Amplifier Design With Dual Reactive Feedback for Broadband Simultaneous Noise and Impedance Matching

Publication Year: 2010, Page(s):795 - 806
Cited by:  Papers (23)
| |PDF (982 KB) | HTML

The simultaneous noise and impedance matching (SNIM) condition for a common-source amplifier is analyzed. Transistor noise parameters are derived based on the more complete hybrid-?? model, and the dominant factors jeopardizing SNIM are identified. Strategies for narrowband and broadband SNIM (BSNIM) are derived accordingly. A dual reactive feedback circuit along with an LC-ladder matching network... View full abstract»

• ### Investigations of AM, PM Noise, and Noise Figure in an SiGe-HBT Amplifier Operating in Linear and Nonlinear Regimes

Publication Year: 2010, Page(s):807 - 813
Cited by:  Papers (6)
| |PDF (907 KB) | HTML

A study of amplitude modulation (AM) and phase modulation (PM) noise has been carried out in an SiGe bipolar amplifier, operating in small- and large-signal conditions. Experimental and simulation results show that the evolution of flicker noise and white noise contributions versus carrier power is different in the AM and PM noise spectra. This indicates that specific mechanisms are involved in th... View full abstract»

• ### Design of an On-Chip Balun With a Minimum Amplitude Imbalance Using a Symmetric Stack Layout

Publication Year: 2010, Page(s):814 - 819
Cited by:  Papers (2)
| |PDF (996 KB) | HTML

This study develops a compact balun layout to minimize amplitude imbalance. Three baluns with different metal layers are fabricated using 0.13-??m CMOS technology and their imbalance performance evaluated. Measurement made using eight metal layers in coil windings at a particular layout reveal that the proposed device exhibits minimal amplitude and phase imbalance of 0.2 dB and ??0.5?? with a chip... View full abstract»

• ### A Resistively Degenerated Wideband Passive Mixer With Low Noise Figure and High ${rm IIP}_{2}$

Publication Year: 2010, Page(s):820 - 830
Cited by:  Papers (28)
| |PDF (1437 KB) | HTML

A CMOS mixer whose linearity is maintained for a wide frequency range is presented. Transconductance (Gm) boosting methods, such as input cross-coupling, current reuse complementary input, and back gate connection, are used to improve overall gain and noise performance. A source-degenerated passive mixer is used to improve noise figure (NF) by increasing the equivalent mixer output impedanc... View full abstract»

• ### Wide-IF-Band CMOS Mixer Design

Publication Year: 2010, Page(s):831 - 840
Cited by:  Papers (12)
| |PDF (1949 KB) | HTML

A wide-IF-band transistor mixer has been designed using a 0.13-??m RF-CMOS process where its RF frequency is 8.7-17.4 GHz, local oscillator (LO) fixed at 17.4 GHz, and IF up to 8.7 GHz. Proper layout arrangement for the Marchand balun has been discussed and then implemented; the output amplitude and phase imbalance are less than 0.5 dB and 1 ?? measured in the RF bandwidth. Related theo... View full abstract»

• ### Low-Noise Waveguide-Type NbN/AlN/NbN SIS Mixers Approaching Terahertz Frequencies

Publication Year: 2010, Page(s):841 - 848
Cited by:  Papers (7)
| |PDF (1683 KB) | HTML

In this paper, we present the development of low-noise waveguide mixers with NbN/AlN/NbN tunnel junctions at a frequency approaching 1 THz. The mixer was designed to be compatible with MgO substrate. Mixers of the presented design demonstrated much improved receiver sensitivity. This improvement is attributed to the reduction in signal dissipation in waveguide and leakage into an intermediate freq... View full abstract»

• ### Broadband Five-Port Direct Receiver Based on Low-Pass and High-Pass Phase Shifters

Publication Year: 2010, Page(s):849 - 853
Cited by:  Papers (6)
| |PDF (1864 KB) | HTML

A simple five-port direct receiver achieving broadband performance and high local oscillator to RF isolation is presented. The new circuit comprises three power detectors exhibiting high series impedance, four resistors, and two low-pass and two high-pass phase shifters. It is shown that the phase-shift networks can be designed to optimize receiver operation over a theoretical decade bandwidth. A ... View full abstract»

• ### A 3–5-GHz UWB Front-End for Low-Data Rate WPANs in 90-nm CMOS

Publication Year: 2010, Page(s):854 - 865
Cited by:  Papers (10)
| |PDF (2491 KB) | HTML

A 3-5-GHz ultra-wideband front-end for low-data rate wireless personal area networks is presented in this paper. The circuit, fabricated in a 90-nm CMOS technology, includes a Gaussian-envelope carrier-based transmitter, a direct-conversion down-converter, and an LO frequency synthesizer. A highly accurate Gaussian pulse shape is achieved by using a nonlinear pulse-forming approach, which provides... View full abstract»

• ### Low-Cost FPGA Implementation of Volterra Series-Based Digital Predistorter for RF Power Amplifiers

Publication Year: 2010, Page(s):866 - 872
Cited by:  Papers (37)  |  Patents (3)
| |PDF (351 KB) | HTML

This paper presents a low-complexity and low-cost hardware implementation of a Volterra series-based digital predistorter (DPD). This is achieved by introducing two novel model complexity reduction techniques into the system, namely, lookup table assisted gain indexing and time-division multiplexing for multiplier sharing. Experimental results show that this novel DPD implementation uses much less... View full abstract»

• ### Linearization of Efficiency-Optimized Dynamic Load Modulation Transmitter Architectures

Publication Year: 2010, Page(s):873 - 881
Cited by:  Papers (32)
| |PDF (1688 KB) | HTML

In this paper, a detailed linearization procedure for dynamic load modulation (DLM) transmitter architectures is proposed for the first time. Compared with the conventional single-input/single-output digital predistortion (DPD) approach used with traditional power amplifiers (PAs), the proposed linearization scheme is based on a regular memory DPD in combination with an efficiency-optimized static... View full abstract»

• ### A New Type of Periodically Loaded Half-Mode Substrate Integrated Waveguide and Its Applications

Publication Year: 2010, Page(s):882 - 893
Cited by:  Papers (26)  |  Patents (1)
| |PDF (2767 KB) | HTML

A new type of half-mode substrate integrated waveguide (SIW) periodically loaded with different lumped elements and structures is proposed in this paper. The propagation constants, Bloch impedances, and voltage distributions of the Floquet TE-modes are all characterized by solving the eigenvalues of the generalized transmission matrix of a single period. Several typical capacitor-loaded, inductor-... View full abstract»

• ### An Automatically Tunable Cavity Resonator System

Publication Year: 2010, Page(s):894 - 902
Cited by:  Papers (3)
| |PDF (497 KB) | HTML

A tunable cavity resonator is described that uses a feedback control system to alter its resonant characteristics in response to changes in its environment, without changing the physical dimensions of the resonator. Tuning wires inserted into the cavity are connected or disconnected to the cavity wall under the control of a binary algorithm that searches for desirable operating states from among a... View full abstract»

## Aims & Scope

The IEEE Transactions on Microwave Theory and Techniques focuses on that part of engineering and theory associated with microwave/millimeter-wave components, devices, circuits, and systems involving the generation, modulation, demodulation, control, transmission, and detection of microwave signals. This includes scientific, technical, and industrial, activities. Microwave theory and techniques relates to electromagnetic waves usually in the frequency region between a few MHz and a THz; other spectral regions and wave types are included within the scope of the Society whenever basic microwave theory and techniques can yield useful results. Generally, this occurs in the theory of wave propagation in structures with dimensions comparable to a wavelength, and in the related techniques for analysis and design..

Full Aims & Scope

## Meet Our Editors

Editor-in-Chief
Luca Perregrini
luca.perregrini@unipv.it

Editor-in-Chief
Jose Carlos Pedro
edit.tmtt@ua.pt