By Topic

# IEEE Transactions on Industrial Electronics and Control Instrumentation

## Filter Results

Displaying Results 1 - 10 of 10

Publication Year: 1965, Page(s): c1
| PDF (557 KB)
• ### IEEE Industrial Electronics and Control Instrumentation Group

Publication Year: 1965, Page(s): c2
| PDF (628 KB)
• ### To the Members of IECI

Publication Year: 1965, Page(s): 43
| PDF (120 KB)
• ### An Improvement of the Critical Inductance Criterion

Publication Year: 1965, Page(s):44 - 46
Cited by:  Papers (3)
| | PDF (1658 KB)

In an inductive input filter for a rectifier-type power supply, critical inductance is the minimum value of inductance which will maintain a continuous current in the inductance. In the usual development of the critical inductance criterion, a small signal, or linear, concept of inductance is implied. Consider a swinging choke'' in which the inductance is allowed to vary with current due to satu... View full abstract»

• ### Orientation and Adhesion of Particles

Publication Year: 1965, Page(s):46 - 50
Cited by:  Papers (2)
| | PDF (3582 KB)

The high adhesion of electrostatically deposited dust as compared to a mechanically pressed sample has been attributed to dipole characteristics of particles and alignment by the field. Recent tests show that if the dust is deposited as single particles and without an electric field a high adhesion is obtained. Other tests indicate that some particles behave like dipoles but most particles appear ... View full abstract»

• ### An Introduction to Sampled-Data Control Systems

Publication Year: 1965, Page(s):51 - 56
| | PDF (1043 KB)

The disciplines of servomechanisms and process-control have been developed for many years. An inherent feature of their practical application was the use of analog components. In an attempt to integrate process-control instrumentation with digital computers and data-processing equipment, it has been necessary to develop new techniques. The underlying mathematical foundation for this treatment is t... View full abstract»

• ### Automatic Charging Methods for Portable Battery Operated Equipment

Publication Year: 1965, Page(s):57 - 62
| | PDF (2707 KB)

A properly designed charger for sealed lead batteries must not only control the current during normal charge, but it must also turn itself off or switch to a float condition when charge is complete; and it must be able to charge batteries which have a very high initial resistance because they have been overdischarged. Many different types of chargers have been developed in the effort to find one t... View full abstract»

• ### Transistor Saturable-Reactor System

Publication Year: 1965, Page(s):62 - 66
| | PDF (1970 KB)

Transistors can be operated as collector-base junction diode switches. In addition, the transistor emitter can be used to regulate the rectification, as a controlled rectifier. Connected in series with a saturable reactor, transistor-reactor network is analyezed as a magnetic amplifier, and characteristic rectified output waveforms are presented. View full abstract»

• ### Control of Ring Magnet Current of the Zero Gradient Synchrotron at Argonne National Laboratory

Publication Year: 1965, Page(s):66 - 77
Cited by:  Papers (4)
| | PDF (4531 KB)

A comprehensive account is given of the control of the ring magnet current for the 12.5 BeV Zero Gradient Synchrotron (ZGS) at Argonne National Laboratory. Pulsing power is supplied by a motor-generator-flywheel set via four groups of 12-phase rectifiers. The rectifier groups operate alternately as power rectifiers and power inverters as directed by their phase control circuits. View full abstract»

• ### Silicon-Controlled Rectifier Positioning Control of Electric Drive Units

Publication Year: 1965, Page(s):78 - 83
Cited by:  Papers (1)
| | PDF (3526 KB)

The control equipment described in this paper has been designed to meet industry demands for electric drive units to adjust loads in the 100-3000 lb-ft torque range with accuracies comparable to those now possible for loads of up to 75 lb-ft. These demands have been accompanied by the now almost standard request that the results be achieved using low-maintenance solid-state equipment. Drive units ... View full abstract»

## Aims & Scope

This Transactions ceased production in 1981. The current retitled publication is IEEE Transactions on Industrial Electronics.

Full Aims & Scope