Switching-Frequency Control for Regulated Discontinuous-Conduction-Mode Boost Rectifiers
Yu-Kang Lo
Jing-Yuan Lin
Sheng-Yuan Ou
Dept. of Electron. Eng., Nat. Taiwan Univ. of Sci. & Technol., Taipei;
This paper appears in: Industrial Electronics, IEEE Transactions on
Publication Date: April 2007
Volume: 54,
Issue: 2
On page(s): 760-768
ISSN: 0278-0046
INSPEC Accession Number: 9400425
Digital Object Identifier: 10.1109/TIE.2007.892104
Current Version Published: 2007-03-12
Abstract
A novel switching-frequency control method for regulated one-switch boost rectifiers operating at the boundary of discontinuous and continuous conduction modes is presented in this paper. To obtain a source current with the least amount of low-order harmonics, the duty cycle within a switching period is proportional to the ratio of the instantaneous value of the source voltage to the output voltage. According to the voltage gain analysis, the output voltage can be regulated by adjusting the switching frequency. Small-signal modeling is performed to facilitate the design process. The proposed control scheme features advantages such as higher input power factor and higher regulated output voltage compared to the traditional discontinuous conduction control with a fixed switching frequency and a constant duty cycle. Any well-developed commercial pulsewidth-modulation control integrated circuit can be adopted with only a minor modification. Experimental results show good conformation with the theoretical analysis
Index
Terms
Available to subscribers and IEEE members.
References
Available to subscribers and IEEE members.
Citing Documents
Available to subscribers and IEEE members.
Cart
