Sliding-mode observer and improved integrator with DC-offset compensation for flux estimation in sensorless-controlled induction motors
Lascu, C.
Andreescu, G.-D.
Dept. of Electr. Eng., Univ. Politehnica of Timisoara, Romania;
This paper appears in: Industrial Electronics, IEEE Transactions on
Publication Date: June 2006
Volume: 53,
Issue: 3
On page(s): 785- 794
ISSN: 0278-0046
INSPEC Accession Number: 8933240
Digital Object Identifier: 10.1109/TIE.2006.874275
Current Version Published: 2006-05-30
Abstract
Two flux observers for wide speed range direct torque control (DTC) of sensorless induction-motor drives are presented and compared. The first one is a full-order sliding-mode observer with proportional plus integral (PI) compensation, without rotor speed adaptation. The second one is based on a zero phase-delay-improved integrator of the voltage model, which uses only a PI flux amplitude control with stator-flux reference magnitude in the correction loop. In both cases, an estimated dc offset is built up and memorized by the PI integral component and this totally compensates for all dc offsets and drifts originated in the acquisition channels. Two feasible solutions for on-line stator-resistance identification are proposed. Simulation and experimental results prove the accuracy, robustness, and high-dynamic performance of both observers when employed in sensorless DTC drives. The effectiveness of state estimation is confirmed by a steady state and transient sensorless operation at very low speed with rated load torque and step-speed reversal.
Index
Terms
Available to subscribers and IEEE members.
References
Available to subscribers and IEEE members.
Citing Documents
Available to subscribers and IEEE members.
Cart
