AC Loss in Pancake Coil Made From 12 mm Wide REBCO Tape

The design of a superconducting coil from high-performance REBCO coated conductors is often complicated because of complex anisotropy of the critical current density
J
_c
. It is important to understand how much detail of this feature must be taken into consideration in the prediction of maximum achievable current and the expected ac loss. We present the results of investigation performed with a small (ten turns, 60 mm inner diameter) coil made from SuperPower tape of 12 mm width. The knowledge of
J
_c
(
B
,θ) determined on short sample allowed prediction of the maximum achievable current of the coil and the ac loss behavior. We have also investigated the effect of the tape nonuniformity. Our results confirm that the lateral nonuniformity when
J
_c
at tape edges is lower than in its center leads to significant increase of ac loss. A longitudinal nonuniformity, in particular a reduction of critical current in some portion along the tape length, is hardly observable in the ac loss result. On the other hand, using a piece of tape with lower
J
_c
in the innermost coil turn would significantly reduce the maximum current. We also present calculations showing the change in current-voltage curve and redistribution of ac dissipation in the case of nonuniform tape quality.