By Topic

A Piezoactuated Droplet-Dispensing Microfluidic Chip

Sign In

Cookies must be enabled to login.After enabling cookies , please use refresh or reload or ctrl+f5 on the browser for the login options.

Formats Non-Member Member
$33 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

4 Author(s)
Mohammed Jalal Ahamed ; Mechatronics and Microsystems Design Laboratory, Department of Mechanical and Industrial Engineering, University of Toronto, Toronto, ON, Canada ; Sergey I. Gubarenko ; Ridha Ben-Mrad ; Pierre Sullivan

A microfluidic dispensing device that is capable of generating droplets with volumes varying between 1 nL and 50 pL at an ejection frequency of up to 6 kHz is presented. In this device, a piezoactuator pushes onto an elastic membrane via piston tips; the mechanical bending of the membrane generates a pressure pulse pushing droplets out. An analytical model was developed solving bending characteristics of a plate-actuated fluidic dispensing system and used to calculate the displaced volume. The model was extended to perform stress analysis to find the optimum piston tip radius by minimizing design stresses. The optimum piston tip radius was found to be 67% of the chamber radius. The actuation force estimated using the analytical model was then used as input to a finite element model of the dispenser. A detailed numerical analysis was then performed to model the fluid flow and droplet ejection process and to find critical geometric and operating parameters. Results from both models were used together to find the best design parameters. The device contains three layers, a silicon layer sandwiched between two polydimethylsiloxane (PDMS) polymer layers. Silicon dry etching, together with PDMS soft lithography, was used to fabricate the chip. PDMS oxygen plasma bonding is used to bond the layers. Prototypes developed were successfully tested to dispense same-sized droplets repeatedly without unwanted droplets. The design allows easy expansion and simultaneous dispensing of fluids.

Published in:

Journal of Microelectromechanical Systems  (Volume:19 ,  Issue: 1 )