Investigation of flip chip under bump metallization systems of Cu pads

In this study, UBM material systems for flip chip solder bumps on Cu pads were investigated using the electroless copper (E-Cu) and electroless nickel (E-Ni) plating methods; and the effects of the interfacial reaction between UBMs and Sn-36Pb-2Ag solders on the solder bump joint reliability were also investigated to optimize UBM materials for flip chip on Cu pads. For the E-Cu UBM, scallop-like Cu/sub 6/Sn/sub 5/, intermetallic compound (IMC) forms at the solder/E-Cu interface, and bump fracture occurred along this interface under a relatively small load. In contrast, at the E-Ni/E-Cu UBM, E-Ni serves as a good diffusion-barrier layer. The E-Ni effectively limited the growth of the IMC at the interface, and the polygonal-shape Ni/sub 3/Sn/sub 4/ IMC resulted in a relatively higher adhesion strength compared with the E-Cu UBM. As a result, electroless deposited UBM systems were successfully demonstrated as low cost UBM alternatives on Cu pads. It was found that the E-Ni/E-Cu UBM material system was a better choice for solder flip chip interconnection on Cu pads than the E-Cu UBM.