By Topic

MEMS milliactuator for hard-disk-drive tracking servo

Sign In

Cookies must be enabled to login.After enabling cookies , please use refresh or reload or ctrl+f5 on the browser for the login options.

Formats Non-Member Member
$31 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

4 Author(s)
Hirano, T. ; Almaden Res. Center, IBM Corp., San Jose, CA, USA ; Long-Sheng Fan ; Gao, J.Q. ; Lee, W.Y.

This paper describes the design, fabrication, and operational characteristics of a MEMS milliactuator designed for servo tracking in a hard-disk drive (HDD). The actuator is designed to increase the bandwidth of an HDD tracking servo and pack more recording tracks on a disk. An Invar (low thermal expansion metal) electrode position process was developed to meet the thermal stability requirement. The electroplated Invar's thermal coefficient of expansion is as low as 6.3×10-6/K, which is almost half of that of pure nickel. For the plating mold pattern definition, a high-aspect-ratio polymer etching technique was developed. A high-aspect-ratio structure line-and-gap definition is required to achieve both a high directional stiffness ratio and electrode efficiency for the actuator. The etching technique described can etch through a thick (<40 μm) polymer layer with an aspect ratio of 16:1 at an etch rate of <2 μm/min. Low-cost/high-volume manufacturing is achievable by this batch fabrication technique. A milliactuator was fabricated and assembled with a suspension and a slider weighted at around 2 mg. The slider was successfully driven by the milliactuator while the slider was flying on a spinning disk. The operational characteristics (frequency response) of the in-flight milliactuator were measured, and the results indicate that the actuator is suitable for high-bandwidth HDD servo-tracking applications

Published in:

Microelectromechanical Systems, Journal of  (Volume:7 ,  Issue: 2 )