Skip to Main Content
Notice of Violation of IEEE Publication Principles
"Design 3.4 GHz Wideband Bandpass Filter Using Two Section of open stub connected in shunt with microstrip lines"
by Majid Shakeri, and Ebrahim Hosseini
in the 2010 Seventh International Conference on Wireless And Optical Communications Networks (WOCN), 2010, pp. 1 - 3.
After careful and considered review of the content and authorship of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE's Publication Principles.
This paper contains significant portions of original text from the paper cited below. The original text was copied with insufficient attribution (including appropriate references to the original author(s) and/or paper title) and without permission.
Due to the nature of this violation, reasonable effort should be made to remove all past references to this paper, and future references should be made to the following article:
"Planar Ultra-Wideband Bandpass Filter Using Edge Coupled Microstrip Lines and Stepped Impedance Open Stub"
by Pramod K. Singh, Sarbani Basu, Yeong-Her Wang Author Name
in the IEEE Microwave and Wireless Components Letters, Vol. 17, Issue 9, , pp. 649 - 651.
This paper presents the 3.4-GHz wideband bandpass filter using coupled compact microstrip-line that the bandwidth of this filter is approximately 55 percent of the central frequency at the return loss of 7.2 dB The parallel-coupled lines at the two sides are longitudinally stretched so as to raise the frequency dispersive coupling degree with the coupling peak near the center of the UWB. The main advantages of this filter are its small size, low cost, high quality factor and low radiation loss.
Date of Conference: 6-8 Sept. 2010