Improved Light Extraction Efficiency in AlGaInP Light-Emitting Diodes by Applying a Periodic Texture on the Surface

In this letter, AlGaInP-GaP-based light-emitting diodes (LEDs) were fabricated with an Si substrate and an SiO
₂
-ITO-Ag omni-directional reflector using a metal-to-metal bonding technique. To enhance light extraction efficiency, a periodic texture was applied to the (Al
_0.5
Ga
_0.5
)
_0.5
In
_0.5
P surface layer of AlGaInP-Si LEDs by photolithography and a wet etching process. The exterior of the etched texture consists of a series of bowl-shaped recesses. With a 350-mA current injection, the typical output power of the AlGaInP-Si LEDs with and without the textured surface (LED-I and LED-II, respectively) were measured at approximately 118 and 81 mW, respectively, when the LED chips were bonded on the TO 46 without resin encapsulation. The enhancement of output power in LED-I can be attributed to a multitude of bowl-shaped notches on the surface, which resulted in a reduction of the reabsorption probability of the photons due to the fact that the photon path length in LED-I is shorter than in LED-II before the photons escape into the free space.