By Topic

Rapid Fabrication of Micromolds for Polymeric Microfluidic Devices

Sign In

Cookies must be enabled to login.After enabling cookies , please use refresh or reload or ctrl+f5 on the browser for the login options.

Formats Non-Member Member
$31 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

4 Author(s)
Pun Pang Shiu ; Nat. Res. Council Canada, London ; Knopf, G.K. ; Ostojic, M. ; Nikumb, S.

Lab-on-a-chip (LOC) and other microfluidic devices for medical applications need to be mass produced at a low fabrication cost because the disposable device is destroyed after a single use to avoid sample contamination. In this paper, a new method for rapidly fabricating metallic micromold masters for manufacturing large volumes of polymeric microfluidic devices is presented. Polymers are preferred over silicon as the device material due to their better compatibility with biological and chemical substances. The manufacturing method involves laser micromachining of the desired imprint features from thin metallic sheets and then microwelding them onto a substrate to form the final mold master. The polydimethylsiloxane (PDMS) elastomer is then poured over the mold and cured to produce the microfluidic device. The proposed method involves fewer processing steps than the soft lithography, electroplating and molding (LIGA) process. To verify the method, a metallic mold for a passive Y-channel microfluidic mixer was fabricated. The mold master was made from low-cost steel and the mold manufacturing process can be completed within an hour. PDMS elastomer is then poured over the mold and cured to produce the mixer. The channels of the mixer were 75 micrometers wide and 50 micrometers high. The mixer created from the mold was tested by mixing two streams of colored water in it. The maximum flow rate achieved by the prototype was 6.4 microlitres per minute. The experimental results confirm that a viable metallic mold master for microfluidic devices can be created by combining laser micromachining and microwelding processes. Finally, the limitations of the proposed rapid fabrication method are discussed.

Published in:

Electrical and Computer Engineering, 2007. CCECE 2007. Canadian Conference on

Date of Conference:

22-26 April 2007