By Topic

A digitally controlled oscillator system for SAW-less transmitters in cellular handsets

Sign In

Cookies must be enabled to login.After enabling cookies , please use refresh or reload or ctrl+f5 on the browser for the login options.

Formats Non-Member Member
$33 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

5 Author(s)
Chih-Ming Hung ; Wireless Analog Technol. Center, Texas Instruments, Dallas, TX, USA ; R. B. Staszewski ; N. Barton ; Meng-Chang Lee
more authors

A complete digitally controlled oscillator (DCO) system for mobile phones is presented with a comprehensive study. The DCO is part of a single-chip fully compliant quad-band GSM transceiver realized in a 90-nm digital CMOS process. By operating the DCO at a 4 × GSM low-band frequency followed by frequency dividers, the requirement of on-chip inductor Q and the amount of gate oxide stress are relaxed. It was found that a dynamic divider is needed for stringent TX output phase noise while a source-coupled-logic divider can be used for RX to save power. Both dividers are capable of producing a tight relation between four quadrature output phases at low voltage and low power. Frequency tuning is achieved through digital control of the varactors which serve as an RF DAC. Combining a MIM capacitor array and two nMOS transistor arrays of the varactors for the RF DAC, a highly linear oscillator gain which is also insensitive to process shift is achieved. The finest varactor step size is 12 kHz at the 1.6-2.0 GHz output. With a sigma-delta dithering, high frequency resolution is obtained while having negligible phase noise degradation. The measured phase noise of -167 dBc/Hz at 20 MHz offset from 915 MHz carrier and frequency tuning range of 24.5% proves that this DCO system can be used in SAW-less quad-band transmitters for mobile phones.

Published in:

IEEE Journal of Solid-State Circuits  (Volume:41 ,  Issue: 5 )