By Topic

Torque redistribution method for fault recovery in redundant serial manipulators

Sign In

Cookies must be enabled to login.After enabling cookies , please use refresh or reload or ctrl+f5 on the browser for the login options.

Formats Non-Member Member
$31 $13
Learn how you can qualify for the best price for this item!
Become an IEEE Member or Subscribe to
IEEE Xplore for exclusive pricing!
close button

puzzle piece

IEEE membership options for an individual and IEEE Xplore subscriptions for an organization offer the most affordable access to essential journal articles, conference papers, standards, eBooks, and eLearning courses.

Learn more about:

IEEE membership

IEEE Xplore subscriptions

3 Author(s)
Yung Ting ; Dept. of Mech. Eng., Texas Univ., Austin, TX, USA ; Tosunoglu, S. ; Freeman, R.

As a robot loses some of its capabilities due to component failure, fault-tolerant controllers isolate the faulty unit and complete the task with minimum performance loss. However, as the robot undergoes a failure and accumulates large errors, controller torque requirements usually increase and may even exceed actuator capacities. This problem can be avoided in redundant serial manipulators if the redundancy of the system is exploited to redistribute the actuator torques. This is accomplished by implementing the controller in the end-effector space. The computed torque method and PID feedback control are used in the controller. When torque demand on an actuator exceeds the allowable limit, that actuator is isolated and the required load is distributed among the remaining actuators. This controller not only avoids the saturation problem, but also allows the robot to eliminate errors and track the original trajectory. Application of the method is demonstrated on a four degree-of-freedom serial manipulator

Published in:

Robotics and Automation, 1994. Proceedings., 1994 IEEE International Conference on

Date of Conference:

8-13 May 1994